Connection, DUT, BUT

Hallo,

I need to connect to the M2M Studio. My board is already connected with my laptop, but it does not appear in the M2M studio, the message says: no compatible devices found. I have done it exactly as what the tutorial says.


Thank you very much.
Best regards,
Siyu

Hi @se171011,

Which operating system do you use? The rapidM2M Studio works best with Microsoft Windwos. It uses the winusb driver. In some cases, this driver is not correctly installed automatically. If this is the case, see “rapidM2M Studio Quick Start” chapter 90 “Device not found on USB”.

Today I also tested it successfully with macOS Sierra. With Linux there are still problems.

Kind regards
Josef

Hi Josef,
Thank you very much!
Have a nice day!
Best regards,

Siyu